Hi, I am trying to enable the monitoring on a cisco 2950-24 switch but when run the command monitor session 1 source ......get the message invalid in put. is this means I cannot enable the SPAN on this switch? Thanks

Hi, We have a Catalyst 3560g switch that has a outdated firmware and we would like to upgrade it. The current version is 12.2(35)SE5. Can I directly upgrade to the latest version? or we have to install them one by one?   Thanks

Hi Guys, I have a cisco catalyst 3950 g that has the defualt config with only 1 vlan. We have give the switch IP address 192.168.130.16 All of the servers connected to the switch are in the range 192.168.130.0/24 we can ping the servers are connecte...

Hi Guy's, We have a Catalyst 3560 Switch that 2 years ago we did setup a SNMP community and an IP address so that only this IP address can read the snmp traps. now the IP of the machine has been changed and we have to also change the community  and I...

Hello,We have an catalyst switch at our data center and we did enable the snmp on this switch and use Cacti to get an grafic chart from the switch, here is what I dont understand,The port one of this switch is connected to the datacenter switch, we h...