Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have been having problems with no video being seen on the far end when calling over ISDN to one particular site (H.323 - ISDN GW - ISDN GW - H.323).We are calling them from an MXP6000 (sw vers F.9.3.1) through our Codian ISDN GW 3241 (sw vers 2.0(...
Having the same issue, started only recently after our CUCM was upgraded to v14. The endpoint shows up in TMS with a Wrong Provisioning Mode error. If I purge it and try to add it from the Add Device from Unified CM or TMS tab, it does not show up. E...
Regarding your question about the Precision 60, you absolutely can connect it to the Codec Pro as a second camera, it is supported in current versions of Room OS & can be used with the PresenterTrack feature.
Yes, you can pair the second one across the LAN. Just make sure in the Plus' Configuration/Peripherals that Remote Pairing is turned on, and TouchPanels is set to 2 or Minimum1.
