Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear Experts, I want to achieve link failover. There are two routers in my setup Router A and Router B. ISP-A ONT wired link is terminated on Router-A and ISP-B Microwave Link is terminated on Router-B. I want to make ISP-B as a PRIMARY wan and ISP-A...
Active supervisor module is working properly in slot 3. Standby supervisor installed in slot 4 stucked in ROMMON mode. I swapped the cards but the result is same. Please help
rommon 4 >
Rom Monitor (P) Version 15.1(1r)SG1Compiled Wed 14-Aug-13 17:15...
dear concerned,I am unable to upload the ios image cisco 3560. please help me in this regard.Base ethernet MAC Address: 00:18:ba:e5:5f:00Xmodem file system is available.The password-recovery mechanism is enabled.Initializing Flash...flashfs[0]: 0 fil...
Dear I already know this command.My question is how many HSRP groups a cisco router 2900 series support ?Any command to check the maximum capacity of HSRP groups on 2900 ?
