Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I need help in creating a redirect ACL (along with an explanation) for one of our sites that has multiple static routes on the router pointing to a customers device on his network. I have attached relevant config for review. We have tried numerious...
In reviewing the documentation for LMS 3.2, I understand the the WAE appliances are supported in RME in this software upgrade. I assume this will only allow us to perform reporting and configuration backups for the devices as we deploy them. It sho...
I assume this is the best place to post regarding IOS. We are beginning the process of upgrading our IOS images on 1841 and 2811 series remote routers. With the new 12.4.24.T2 code in advance enterprise the min. memory required is 256MB. Our route...
We are attempting to upgrade some of our routers to a new image that is recommended to have a 128MB flash, but our routers only have the 64MB flash. The image is only around 58MB and loads without any problems via TFTP from a PC. However, RME will ...
We are in the process of looking for a code to begin ZBF implementation. Currently we have tried about 4 versions of 12.4 T code lines and have encountered the same issue each time. If we have two subnets configured on the same interface, with insp...
The images we have tried are:c1841-adventerprisek9-mz.124-22.T3.binc1841-adventerprisek9-mz.124-24.T.binc1841-adventerprisek9-mz.124-20.T4.binAlso experienced the same with a 2811 router running c2800nm-advipservicesk9-mz.124-15.T9 We are inspecting ...
Excellent information.....it will be awhile before we can test this, but looking over some documents PBR should accomplish what we are trying to do. I will advise the discussion when we see what happens
