Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HI All, I have some concern on congestion that happens on interface. On C3K I can see some output drops which are present on 10 Gbps interface. Utilization of this interface is maybe around 2 Gbps so it's not havely utilized but the output drops are ...
Hi Team, We manage the UCS-C240 server with VIC1457 card in standalone mode. VIC 1457 have four ports that can be setup in two operating modes1) Individual link (4 ports)2) Port channel modeWhen i use port channel mode then port pair are created 1/2 ...
Hi, I have problem with connecting ucs-c240m5 with molom vic1457 to fi6248. There are factory settings on ucs server. I have connect vic1457 port 1 to fiA and vic1457 port 3 to fiB and server was discovered correctly but without any vic cards and now...
Hi,I have question regarding hardware setup for the SD-WAN deployment. Can we setup vManage, vSmart and vBond on the same physical server for production (if resources are sufficient) and redundancy is achieved by lower level like vmware? Any argues a...
Hi All,I have some missunderstunding about VLAN interface packet processing. Please confirm the patch:1.IP Packet incoming on the vlan 10 access interface2.Switch decapsulate the L2 header and check if it has dst MAC address in it's MAC table. In thi...
Yes, I used this command: qos queue-softmax-multiplier 1200 But it only partially helps. Less drops but still visible.But my question is more general. Is it possible to have congested interface when it's not highly utilized ? I think this is actually...
Many thanks ! Looks very similar to my issue. I will check this probably tommorow when have access to the system. But, what is the solution for this bug ? The description mention about the unused ports and that this is cosmetic issue what is not true...
