Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, We have now been struggling for some hours trying to figure out the problem with receiving webhooks. We have it working with http but with https it keeps failing.We have installed a Self signed certificate and it seems like that is the problem?We...
HiI have run in to a problem with EIGRP and redundant configuration.We are about to migrate to a solution with existing hub and spoke routers but this time we will add redundancy at the central site.The connection between the two central Hubs and the...
Hi all,I’m trying to replace an existing VMPS installation with MAB on ACS 5.2. To keep it simple I just want Use Internal Identity Stores à HostI have a lab environment that is working, but not in the way I want…. The risk of typo it to large....I h...
Hi I have an issue with the CSS11503 running och version 7.40.2.02we loadbalance between two services and when we do some upgrades on one servise we suspend the service in the Css. Then we look at the IP FLOW and the Address of one host we can see fl...
Hi, I would like to authenticat users that dial in with use of certifcate.how can this be done. I have Cisco router (in lab 1720) with ISDN BRI and dial-in user are XP-client the user is autenticated against radious (this is working fine with users i...
Thanks for youre inputwhat If I configure different subnets on the central hub routers and configure secondary ip on the spoke what will happen? can this fake two different "links" in the same broadcastdomain?///Anders
HiI want the spoke to be neighbor with the two central hub routers, but i do not want the hub to be neighbors on the same interface.....there is only one interface in the spoke and one interface in both the hub all 3 interfaces ( spoke and the two hu...
THX for your answers,I have twist and turn this problem and I see no way around it. It seems like it going to be a lot of configuration in ACS but it is only for one time. It better to do that job with the installation rather than troubleshoot every ...
