Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I have a Cisco Catalyst 4500 and i want to associate a route map for PBR to one of his interfaces. 1) i found out that i can only associate it to interface vlans and not to regular Gigabit interfaces - is it impossible to associate a route map to ...
Hi, the question is: Can i use static routes that target ipv6 traffic with ipv4 targets?What i mean is: let's say i have an ipv6 client, and my cisco is his ipv6 default gateway. Can i set a route in the Cisco that looks something like this:ip route ...
In order to configure something like this i first need to understand something - i have read a lot about IPv6 but i didn't understand something:This is the stature of an IPv6 address, and the confusing part to me is the 0012 - the subnet. ...
Hi,I have Catalyst 4500 L3 Switch Software (cat4500-IPBASEK9-M), Version 12.2(52)SG, RELEASE SOFTWARE (fc1)System image file is "bootflash:cat4500-ipbasek9-mz.122-52.SG.bin"I know that PBR isn't supported because it's a basic version and not IP Servi...
Yes, i have an Interface Vlan for the IT connectivity (i.e. - a layer 3 virtual interface). So i have associated the route map there (we haven't tested it yet, but... we'll test it later today).Question about route maps - when traffic is examined aga...
Hi,There is a connectivity interface vlan on the switch to the IT that all traffic from the IT is being routed to suing static routes, but when i checked the ARP table for that vlan there were only 2 mac addresses there (1 of my switch and another of...
Hi,As i have explained earlier I am trying to route using PBR traffic that's incoming to the LAN to a certain address or via a certain TCP port to a specific host in the LAN. But the switch which is under my control doesn’t have layer 3 physical inte...
