Hi! Cisco newbie here. I created a number of VLANs for our network on a series or Cisco 2960 switches and I found myself using VLAN 1 because, you know, newbie.I would like to move the VLAN 1 configuration to an appropriately named VLAN. This include...
Hi
I have a load balancer I am trying to nat multiple ports to (at this time, http and https) behind an ASA 5515.
I have created a service group for the nat ports:
object-group service webServices service-object tcp destination eq www service-obj...
HiPlease I need some assistance with a site-to-site VPN I have setup with a Cisco 1941 router and a Linux-based VPN concentrator (Sophos UTM).The VPN is established between them, but I cannot seem to tell the cisco router to send and recieve traffic...
This is what I ended up doing, which works, despite complaints of something overlapping from the ASA. It doesn't conflict with anything else.
I am worried if later rules might make trouble if they are similar. Any advice?
My config:
object-group ser...
Yes, the VPN tunnel works as expected.ip route 0.0.0.0 0.0.0.0 62.X.X..121ip route 0.0.0.0 0.0.0.0 62.172.32.121 They are actually the same route, and I actually wonder at which point I created the two lines, because if I take out any of them, traffi...
Dear Richard,Thank you very much for your reply, and I'm awfully sorry I have not responded for so long. Lots of issues, including a data center fire, leading to lots of unpaid work and sleepless nights! Thanks to your assistance I've been able to ri...
Thank you very much. I'd been tinkering before your reply came in, I was actually a little wary of removing theip nat pool mypool 62.X.X..122 62.X.X..122 prefix-length 30line. ( I inherited the configuration off of a previous admin.) I've also been ...
Thank you for all your help so far.The first nat rule is for 192.168.20.0 to go through to the internet.The second nat rule is supposed to be for sending traffic through the tunnel I believe.. I got information from this link:http://www.firewall.cx/...
