Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have a WLC running 8.2.121.0 that has Wireless 802.11b > RRM > Tx Power Control(TPC)) > Minimum Power Level Assignment set to 10 dBm. On a 2802 AP, that should be about power level 5. The WLC Power Level Assignment Method is automatic. The APs are...
I created several configuration templates in Cisco Prime Infrastructure 2.2 under "Features & Technologies" that Prime said were successfully created. However, they do not appear in the list, or anywhere else in PI. I then try to create it again with...
Using CPI 2.2.0, I sent a request to the WlanControllerDetail resource and get incorrect counts for dot11aClientCount and dot11bClientCount. For example, a response will report 134 dot11aClientCount and 241 dot11bClientCount when the GUI Summary page...
The other error I noticed are with the webacs/api/v1/data/Sites and webacs/api/v1/op/groups/sites queries.The apCount is almost always zero for buildings and floor areas that have many access points.
