Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am setting up a stack of three WS-C3650-48FD. Software version 3.3.3SE and Image version cat3k_caa-universalk9. When I apply the following route map:
route-map STATIC-2-EIGRP permit 40 match tag 400 set tag 400
I get the following message:
Erro...
Hello All, I will have a 3 stack of 3650's. One switch will have the IP base image and the other two will have a LAN base image. I have read that all switches in the stack must have the exact image. If I have an IP based image and a LAN based imag...
I have a stack of three 2960s using stack wise cables to make them into one logical switch. I have two 4500x switches stacked via VSS. The 2960 top switch will be trunked to the 4500x top switch and the 2960 bottom switch will be trunked to the 4500...
Tomorrow I will be setting up a simple router and switch configuration in a small office. The network will be a flat network with no seperate vlan for voice and data. We will have Cisco 7961 Cisco phones connecting back to our main office via a sit...
Hello All,I am looking to redistribute a static route with a weight into an EIGRP table. For example I used the commands: ip route 192.168.1.0/24 172.16.1.10 200router eigrp 100 network 172.16.0.0/16 redistribute staticWhen the static route is inj...
One last thing that confused us is that when we enter "auto qos voip trust" to the uplink/trunk interface, it changes it to "auto qos trust" when we view the running config. Do you know why this happens? is it the same thing?
rajeevsh,We are cuurently using a Cisco phone system. We setup auto qos on the switch ports including the uplink trunk ports. When we setup auto qos voip trust on the uplink trunk port while the port is a member of a port channel, it does not let u...
Rajeevsh, If we don't want to rely on etherchannel hello negotitations between stacks, do you recommend we use the "on" mode? This will give us more manual control?
