I am setting up a stack of three WS-C3650-48FD. Software version 3.3.3SE and Image version cat3k_caa-universalk9. When I apply the following route map:
route-map STATIC-2-EIGRP permit 40
match tag 400
set tag 400
I get the following message:
Error Message PLATFORM_PBR-3-UNSUPPORTED_RMAP: Route-map [chars] not supported for
Policy-Based Routing
Explanation This message means that the route-map attached to an interface for policy routing contains an action that is not supported on this platform. This is a hardware limitation. [chars] is the route-map.
Recommended Action Use the route-map map-tag permit global configuration command and the set ip next-hop ip-address route-map configuration command to reconfigure the route map to use only these supported actions.
My other route maps will match tags, apply tags and match ip address prefix-lists. The IOS software still accepts the commands and will show int he running config. Does this mean my route maps will not work because of the hardware limitation? Why does it take the command if it doesn't support it?