Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi, guys,
"Total output drops" are found in some switchports of my Cat9200L stack ( two switches stack ), that uses IOS XE Version 17.09.04a; and the "qos queue-softmax-multiplier 1200" can not solved the problem of all switchports, so I tried to con...
Hi, guys, I have the ASR1001-X, with the IOS version: ASR1000 Software (X86_64_LINUX_IOSD-UNIVERSALK9-M), Version 15.4(3)S2; 01RtA1001x#sh licenseIndex 1 Feature: adventerprisePeriod left: Life timeLicense Type: PermanentLicense State: Active, In Use...
Hi, guys, We have a Catalyst 9300 switch stack running ( three switches stacking, each switch has two power supplies ); and the devices information as below: Switch Ports Model SW Version SW Image Mode------ ----- ----- ---------- ---------- ----* 1 ...
Hi, guys, If any configuration sample ( EEM, TCL..or what else ) of the Cisco CLI script to export the result:1. the script task is triggered by some conditions, such as "80% interface traffic utilization" is reached2. execute and export the result,...
Hi, Guys, I am far away from such configuration.Any document or article about the these configuration in Cat3850 and Cat9300 ? I would like to enable the netflow in the latest switches, in order to check/inspect network traffic within the devices in ...
Hi, BB, You are correct. The IOS version version 15.4 has no this feature, while the "Version 16.6.4" has the feature ( the same license level RtA1001xPrd2#show flow monitor NETFLOW-1 cache sort highest counterpac$onitor NETFLOW-1 cache sort highes...
Hi, BB, Sorry for my previous messages. I did configure the flexible netflow as below:Router(config-if#) interface GigabitEthernet0/0/2Router(config-if#) ip flow monitor NETFLOW-1 inputrouter(config-if#) end so I could issue the following command ( ...
Hi, Marce, Sure, We shall replace a new supply;secondly, we also want to confirm it is not a software issue. So, your guys advices are highly appreciated.
Hi, Leo,Your recommendation may be correct, according to the articles written in the community.However, these bugs have been fixed ( or the one we found ) with the IOS version "Gibraltar-16.12.04" ?? such as : 1. bug CSCvn40414.2. bug/CSCvo312...
Catalyst 9300 is found also this problem: Catalyst 9300 switch : FRU power supply B powered off ( Status --- Disabled ) - Cisco Community The onsite engineer also reported the RED/AMBER LED was blinking while he reached at the spot. " Disabled : Th...
