I received a config from my vendor that they usualy put on a SF300 for their managed voice. Looks like you configure general ports and PVID's to allow two vlans on one port. Is this the same as switchport voice vlan <vlanid> ? Also in the configuration I see the following voice vlan id 20
voice vlan state disabled
voice vlan oui-table add 0001e3 Siemens_AG_phone________
voice vlan oui-table add 00036b Cisco_phone_____________
voice vlan oui-table add 00096e Avaya___________________
voice vlan oui-table add 000fe2 H3C_Aolynk______________
voice vlan oui-table add 0060b9 Philips_and_NEC_AG_phone
voice vlan oui-table add 00d01e Pingtel_phone___________
voice vlan oui-table add 00e075 Polycom/Veritel_phone___
voice vlan oui-table add 00e0bb 3Com_phone______________ This config won't work on my 3550 and 3560 switches. It seems this is some auto vlan config, how would this translate on a 3550 or a 3560? or is it needed at all?
... View more
Hello, I was doing a Lab in packet tracer: two switches (2960's) and 3 end devices. On sw1 pc1 is connected to int fa0/11 and pc 3 is connected to int fa0/13. Both int belong to vlan 11 & 13 On sw2 PC 2 is connected to fa0/12 also belonging to vlan 11. In this set up I can ping all devices. However the only mac address being added to the mac table are the def. int macs of each switches port. When I remove all int from vlan 11 & 13 and add them to native vlan 1 mac's are being added to the table. Am I doing something wrong, or is this a flaw with Packet tracer.
... View more