Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,I configured an ASA5512 with the integrated IPS software module. I am having issues connecting to the software module. The IPS software module is running and I have configured it for the same subnet as my inside interface. When I click on the I...
Hello, I have one 48 port SGE2010 and one 24 port SGE2000P at separate sites that are connected with single-mode fiber. I was wondering if the SGE's will support 10gb Mini GBIC transceivers or only 1gb Mini GBIC transceivers? I would like to connect ...
Hello,I am trying to configure CUPS (version in title) in a new LAN segment. I will be using CUPS to run Jabber. I am stuck on the post install setup. What exactly should I be using for the AXL username and password? I know I did set a password for n...
Hello,I am somehwat new to Cisco and routing. I have an installation of two ASA 5505's that are setup for site-to-site vpn as well as AnyConnect. The AnyConnect subnet can connect into the inside vlan at SiteA but I cannot get to the remote subnet at...
Hello,I have configured AnyConnect to use a 10.0.7.0/24 subnet for it's DHCP pool. I can connect to the ASA just fine, but I cannot access any internal services on my 10.0.5.0/24 subnet which is my INSIDE interface vlan subnet. I have setup a NAT exe...
OK thanks. They are about a year and a half old. I am trying to improve the speed between the two sites. I currently have an ethernet to fiber convertor at 1Gb.I would like to improve this link to at least 2Gb. If I find a 2Gb convertor would the two...
So I am still not able to access the internet from an AnyConnect VPN client with IP address 10.0.7.5 on the /24 subnet. I can access internal services. When I do the packet trace I get an access list error:Interface: OutsideSource IP Address: 10.0.7....
OK - Thanks Jouni. I ran the show run all sysopt and got these results:show run all sysoptno sysopt connection timewaitsysopt connection tcpmss 1380sysopt connection tcpmss minimum 0sysopt connection permit-vpnsysopt connection reclassify-vpnno sysop...
Jouni,Thanks for the reply. I just tried to browse to an internal webserver and that worked. Why would ICMP packets not be returning back through the FW? I am pinging an internal fileserver. Also, what do I need to do to allow http/https traffic thro...
