Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have Site to Site VPN setup between few servers to a vendor. However seems all traffic including these servers internet destined traffic is also passing through the S2S VPN. How should I exempt internet traffic from S2S VPN
Hi, Setting up site to site VPN from ASA 5555 (FTD) to a clients firewall. Do I use the firewalls Outside interface IP address as VPN source IP NAT or an IP from the ISP assigned public range? Also will the private host IPs be NAT'd as the source IP...
HI, I am trying to have the DCI routers and MPLS routers as OSPF neighbors with ACI.Tried configuring multiple L3Outs on the border leaf with same OSPF process ID and it won’t allow me to. Per Cisco docs this is not allowed. Do I have to have separat...
HI, I was configuring multiple L3Outs on the same leaf with same OSPF area 0 and got the attached error. Cisco docs says this is not allowed. I want my border leafs to be OSPF peers with my DCI and MPLS routers. Is this not possible with ACI??
I can ping the gateway from a switch connected through L3Out (ospf) but not the VMs. I see the VM IPs under operational tab of the EPG and they are being learned. I see all the routes being learned through OSPF on the L3Out. Also I can see the ospf ...
Thanks for the response. For VPN setup, the peer IP would be the FTD's outside interface IP and under NAT rules I will have to configure the PAT for the source IPs to translate to the Public IP from the NAT range. correct?
When configuring the VPN through FMC it only gives me option to select the interface and auto populates the IP address. How do I use an IP from the public NAT range as VPN tunnel IP?
Thanks Eduman for the quick response. So if I am setting up multiple S2S VPNs with different peers I can use a unique IP from the public NAT range for each S2S VPN connection? Or use the one internet IP (FW Outside interface) for all S2S commections....
removed the ' ip ospf mtu-ignore' on both sides and hardcoded the mtu size on Cat4k switch interface to 9000 and the neighbor state changed to Full The mtu-ignore probably didn't work due to some bug.
