Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,
I have a problem with my "6500 CORE" at the HSRP level
Basically, when I send down the vlan interface of DC1 I quit dripping that network ... from either side the answer is the same = "Request timed out." If I disconnect on DC2, I will not h...
hello,
I'm implementing ACL's on my company's , but I came across a problem.
I want to filter the protocols that go to the network of printers, allowing only PING, 9100, 161 (snmp) and web access only to a specific network.
Everything works except ...
I have several autonomous AP with multiple ssids ...I wanted to apply QoS (limit download speed and upload) for a specific wlan...how can I do ??basically I wanted to limit speed to 4Mbps for all equipment that were in that WLAN.it's possible??In WLC...
someone tell me how can I force the AP 1602i sending HOST-IP attribute (wireless client) when the AP has set up a rule to send radius acct to another device?someone tell me how can I force the AP 1602i sending HOST-IP attribute (wireless client) wh...
I need your help ... I need capture all the traffic that goes from a wireless client 802.1x to AP and the AP to RADIUS and Customer . I connected a computer to a switch port where the AP is connected and configured as follows:
monitor session 1 sou...
Yes it makes sense, because from my pc I go to DC1 and if the vlan interface is down the package is no longer sent to another side ...
see the attachment please.
status HSRP is:
DC1=
sw_cpd1_core#sh standby vlan 24Vlan24 - Group 24 State is Init (interface down) 2 state changes, last state change 00:00:29 Virtual IP address is 172.20.24.254 Active virtual MAC address is unknown Local virtual MAC address is 00...
I leave the HSRP scheme I have mounted.
I'm basically ping the GW 172.20.24.254 from my laptop and the other physical interfaces of each CORE (172.20.24.252 & 172.20.24.253).
When I turn off the vlan interface on DC1,i lose the connection to that ...
i know that, but is an best pratique...
"Although all access lists end with an implicit deny statement, we recommend use of an explicit deny statement (for example, deny ip any any). On most platforms, you can display the count of packets denied by ...
