Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,
there is a eem configuration which is using in my new job. I try to slove what does it do but i am confused. could anyone please light me about the configuration below. i don't understand the condition of the conf. because of that i on...
Hello Everyone,
I have some questions about the subject. So i want to upgrade my software release 7.5.102.0 to 8.0.152.0. When i looked 8.0.152.0 release notes, there is a table for transition between softwares. As the table i can just upgrade soft...
When i was looking for Cisco Nexus 9k series model switch, it was mentioned 2 types of mode. One of them is ACI mode and the other one is NX-OS mode. I searched smth about them but I couldn't find any utility information. So is there anyone to explai...
Hi everybody,
I want to ask all of you about DCA settings on my WLC. I attached my DCA conf. In my topology there are 10 APs. But as you can see the attached files, APs usually choose channel 1. Is there smth i'm doing wrong? I can share other settin...
I have two Cisco WLC 5508 and they are working with redundancy on SSO mode. So can i use 802.11k feature on these controller. Because on documents,it is written on 802.11k title "do not use this feature with multiple controller". Does Redundancy SSO ...
Here it is;
track 1 ip sla 1 reachability!track 3 list boolean or object 4 object 5!track 4 ip sla 4 reachability!track 5 ip sla 5 reachability
----
ip sla auto discoveryip sla 1 icmp-echo 10.z.z.z source-interface BVI1ip sla schedule 1 life foreve...
Thanx for your replies. Then i will upgrade my FUS image with my ios. Is there any difference upgrade process between ios and fus? I have 2 WLC which are working in AP SSO mode. Is the same upgrade procedure that Cisco recommends for both the FUS and...
So can we say ACI mode has much more feature than NX-OS mode? Do you know is there any expense difference between modes? Because it should be a cause why Cisco seperate them.
They are in a Warehouse. I also know how my software is but i afraid smth going bad after upgrading. By the way i use two controller active/hot standby. So are there any document about upgrading software on redundancy mode?
