Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We are facing an issue with CW9178I and CW9136I access points on the same CW9800M WLC.
Setup Details:
WLC Model: Catalyst 9800M
Access Point Models: CW9178I and CW9136I
Country Code: QA (Qatar)
Issue Description:
On IOS-XE 17.15.3, the CW9178I A...
Hi
We registered some new APs of model C9124AXE-ROW with our existing controller.All new APs admin status is up but operational status is down, WLC version is 17.6.4.All APs are in local mode, WLC is configured with only one country code QA, APs are ...
Hello,
We want to set all lightweight APs time zone which are registered with 9800 controller.In AirOS controller we can do this with command "config ap timezone enable use-controller all"
Is there any equivalent command for WLC 9800 or any other wor...
After upgrading WLC code MSE not showing clients on PI maps, we are not able to synchronize maps with MSE. NMSP connection status is actvie, MSE main page active floor, active AP and active zone showing zero.
Any help would be graeatly appriciated...
We have one primary controller 2504 with 15 AP license and secondary 2504 HA without license, evey thing is working fine.But when i am going to login to secondary controller i am getting the message "License base-ap-count is expiring in 11 weeks, 5...
TAC has resolved the issue.We were observing the following messages on the AP console:
[*11/02/2025 12:49:08.4292] sh: write error: No space left on device
[*11/02/2025 12:49:08.4534] tar: write error: No space left on device
!
!
!
[*11/02/2025 12:4...
I will validate the show tech wireless output using the Wireless Config Analyzer.The full AP model is C9136I-ROW.Please find the boot sequence and debug trace of AP 9136 attached
Radios operation status is up after changing country code QA to GB but still interface regulatory domain showing Unknown. We are plaining to upgrade WLC version, will update status after WLC upgrade.
Yes, AP join profile is configured with proper country code and country is enabled in global country list.APs are getting country from AP join profile, country is part of the -ROW domain. APs are not showing any config mismatch but both the radios ar...
