Any support please ... View more

Still we are waiting for someone to response to this Question. We found an article on connecting disjoint networks with Cisco UCS (https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/unified-computing/white_paper_c11-692008.html). We plan to make configuration as mentioned below:- We will create new global VLANs (for eg:50, 51 & 52) for the DMZ, these VLANs will only be available to DMZ organization. The above mentioned VLANs will be assigned to uplinks connected to DMZ switch (from each FIs we connected port 1/10 to single DMZ switch) We configured port channel with upstream single DMZ switch, is this configuration needed or no need for port channel with upstream switch? With UCS vNICs we usually configure fabric level failover, that’s why we confused on Port channel with upstream switch, please clarify.                  All other existing VLANs will be assigned to existing port channel which is connected to 2 X N9Ks.      3. We are using both Microsoft HV 2016 & VMWare. We configured vNICs as mentioned below:- HV 2016 Specific Comments VMWare Specific Comments *CSV_vNIC_FB Using for CSV traffic, Single native VLAN configured     *LM_vNIC_FA Using for Live Migration traffic, Single native VLAN configured #vMotion_vNIC_FA Using for vMotion traffic, Single native VLAN configured *Mgmt_vNIC_FA Using for Management traffic, Single native VLAN configured #Mgmt_vNIC_FA Using for Management traffic, Single native VLAN configured VM1_vNIC_FA Assigned to Odd slot blades with multiple VLANs, using for VMs VM1_vNIC_FA Assigned to Odd slot blades with multiple VLANs, using for VMs VM2_vNIC_FB Assigned to Even slot blades with multiple VLANs, using for VMs VM2_vNIC_FB Assigned to Even slot blades with multiple VLANs, using for VMs * The 3 vNICs are assigned to all HV hosts                     # The 2 vNICs are assigned to all ESXi hosts   When we assign VLANs to uplinks / port channel receive below alert, hope these won’t affect any of these vNICs and connected VLANs in production                               4. With the KB “https://www.cisco.com/c/en/us/solutions/collateral/data-center-virtualization/unified-computing/white_paper_c11-692008.html” it says to remove the default VLAN1 membership from upstream switch, do we need to remove default VLAN1 on all N9K & DMZ switches? (I believe it's not possible)   Than You     ... View more

Thank You Kirk.   But our concern is why IOM & Server DCE interface shows only a single connection instead of 2? Is it because of port channel configuration? If so how can we see the 2 connections from each server to each IOMs?   ... View more