Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
HelloI know this thread is a bit old but I believe what you were just concerned with were the routes that originate from a particular router. This command should do the trick. show ip ospf database self-originate
I resolved the issue. I’ll give you some details so you can put this in your toolbox for the future. We have an HA pair of 5520’s deployed in this scenario. The COA was being sent from ISE to our foreign controller, as it should be. COA does not ...
Greg,Thanks for taking the time to respond. I do have the ACL on both the foreign and anchor WLC's (all four really). It does seem to point to the anchor wlc at the remote office, or potentially the firewall at that location, however I do not see a...
A little additional information. I have an foreign/anchor pair at one of my remote sites where this is failing. I also have a foreign anchor pair here at headquarters that I proofed this on where things work. I move the mobility tunnel from my rem...
