Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have 4 controllers running on our network - three 4400 series & one 5508 model.
The 4400 controllers are on Software Version 7.0.250.0
The 5508 controller is on 8.0.120.0 and Field Recovery Image Version for this is 6.0.182.0
Could someone please ...
Great! That clears the confusion. Because the whole thing was configured by a company few years back, so just needed to make sure before I proceed.
Thanks philip for your help!
Yes, we do have the gateway configured on the 'Inteface' on the WLC. What I meant was its just not set to the IP address of that VLAN, instead set to the gateway of that VLAN subnet.
So, lets say the subnet range for my working WLAN/VLAN is 172.16.19...
Thanks philip!
So basically, if I have 2 controllers & 2 different VLAN interfaces, then I would need to assign a total of 4 unique ip addresses, that is, assigned per interface per controller, is that correct?
The "gateway" would typically point t...
@JDMJeffy84Got a question for you, just for myself to understand the config - why do you have:!!ip dns serverip nat inside source list 1 interface Dialer1 overloadip route 0.0.0.0 0.0.0.0 Dialer1 interface Dialer0!!ip dns serverip nat inside source l...
