Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
Is this a problem with sg300 not being stackable -
We have an sg500 stack and all the switches happily communicate over the voice vlan (10) and the default data vlan (1). I have connected an sg300 to the core switch, created voice vlan 10 on it, ...
HiI have an ASA5512 and need to spilt traffic off a voice vlan to exit via two external interfaces (one traffic is voice and one is voice application). So I have one internal interface and two external interfaces. From the LAN I can ping the next hop...
HiI need to connect a router to a voice vlan port to allow all voice traffic to exit the VLAN without having to transverse onto the data vlan and use its gateway.However any device I assign to a voice vlan port is ignored by the switch if it isn’t a ...
HiWe have a stack of sg500x switches and are using the auto voice vlan for voip. Phones pick up their ip from the correct scope and auto smartport recognises the phones when plugged into the switch and assigns them to the correct vlan. Have configure...
We need a firewall on our VOIP traffic. Our provider says the device must have a maxium latency of 2ms. Having searched the spec in the Cisco docs on this device and having found nothing on it's latency I wondered if anyone on here might know?Thanks
Thanks RichardSorry for the lack of detail on this problem. What I had done was place the static routes on the internal network adapter. My thinking being that it would need to know to which external facing interface it had to use to route traffic it...
Thanks RickI’m new to Cisco and having used other firewalls which use the term ‘incoming’ for traffic coming off the cloud and ‘outgoing’ as traffic leaving the protected network so having to change my thinking. I didn’t know about the security level...
Needed a sub interface on the ASA assigned to voice vlan and details on physical interface left blank as in this thread - https://supportforums.cisco.com/thread/2206103
Sub interface now working once I deleted all the detail from the phyiscal interface as in this thread https://supportforums.cisco.com/thread/2206103Can't mark my own answer as correct..........
