Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Dear all, Let's say you make two users "bob" and "peter".Bob has an privilege level of 15 and peter of 1.So I do:username bob privilege 15 secret 0 bob-and-username peter privilege 1 secret 0 peter Now when I hit "show run" I see:username bob secret ...
Hello all,I'm currently bus with RIPv2 and I get the hole picture, except default-information originate!What does it do?I searched on the internet and found something on default route to the ISP??All the suggestions and answers are welcome!!
Hello all,I want to set up a dhcp-relay.There are 2 routers one is the dhcp server the other one is the forwarder.Please see the attached file (from Cisco packet tracer).The pc on the right side only give my a message with a failure of retrieving a i...
Dear Readers,Currently I'm learning for CCENT. I have packet tracer from Cisco, but after some advice about a real lab I started searching the web. Specially for the 871(W), but without any luck. Yes there is a lot on Ebay and such, but I don't liv...
Ok here we go,Pc is dhcp not staticForwarder (I removed some of the "!" there were a lot of them Building configuration...Current configuration : 473 bytes!version 12.2no service timestamps log datetime msecno service timestamps debug datetime msecn...
