Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello All, It's been a while since I've done this, but don't seem to remember having this much difficulty in the past. Trying to connect CUCM 10 to Exchange 2010 UM via direct SIP trunk. I've created the trunk, and it appears as if calls are traver...
I have a WLC 4400 series and am using 1142n APs. Am planning on adding Wireless IP Phones such as 7921/7925 as well as a couple 9971's. Is it possible to have 2 WLANs, one to connect the voice endpoints to running @ 2.4GHz and another WLAN with a d...
Hello All,It's been a little while since I've ealt with Cisco's Presence solution. Last time was in CUCM/CUPS 7.x train. Trying to get things setup with CUCM 10 and IM and Presence (CUPS replacement?) 10, also Jabber Windows 9.6 running on Windows ...
Hello All,It's been a little while since I've ealt with Cisco's Presence solution. Last time was in CUCM/CUPS 7.x train. Trying to get things setup with CUCM 10 and IM and Presence (CUPS replacement?) 10, also Jabber Windows 9.6 running on Windows ...
Hello All,I have what I'm sure is a simple question, but is frustrating me. I'd like to enable ICMP response on the outside interface of my ASA's to respond to ICMP traffic that is sent from a specific DNS address (an external monitoring service). ...
For what it's worth (I know this question has been here for a long time) I've found that using port-channels with iSCSI is not as good as using MPIO setup correctly. iSCSI isn't too complicated, but certain prerequisites do have to be met in order f...
Thank you for your prompt response. I only have 1 WLC, it is a 4402-50. I believe that 7.0.240 is the most current release for that model. I think anything higher I need to go to the WLC5508 (or vWLC?)Also, I wasn't aware that the 7921/25 were 5GH...
Jonathan,Thanks for your prompt and detailed reply. In regards to:what I remember from CUPC/CUPC is that when a user was "off-hook" that presence status would reflect on the CUPC client, whether the user was using a softphone or tethered desk phone ...
My sincere apologies for not replying sooner. I've been away and unable to respond quicker. Thank you very much for your quick answer. Looks like IP Pool is the way to go in this case. Once again, thank you.
