Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi
I have a cisco 3845 with DS-3 connected to serial interface 4/0 it is working good with IOS version 12.4(3g)
interface Serial4/0 description Sprint MPLS DS-3 (NUA-46120459) bandwidth 44210 ip address 10.0.0.2 255.255.255.252 ip wccp 62 redirect i...
HiI have a ws-c2960-48tc-l switch with ios version: " C2960 Software (C2960-LANBASE-M), Version 12.2(44)SE2, RELEASE SOFTWARE (fc2) ",JUAFINASW1#sh verCisco IOS Software, C2960 Software (C2960-LANBASE-M), Version 12.2(44)SE2, RELEASE SOFTWARE (fc2)Co...
Hi, I have a new fiber connection to close my network, but when I tray to connect my Build 3 switch with my Build 2 switch, it does a loop and I need to unplug the fiber, this is the configuration on that portsBuild 2, WS-C4503 switchinterface Gigabi...
Hi I'm new in Wan configurations, and I have Cisco 2851 IOS 12.4(3i) we will to increase our WAN connection in 20MB and I need to install a Wan interface to support this, but I do not know what model of interface can I use, I verify in cisco and see ...
I have some Access Point model AIR-AP1231G-A-K9 with system software version 12.3(8)JED and bootloader version 12.3(2)JA4, I need change the security to WPA version 2, but this model only have WPA version 1 with TKIP, Could you tell me if I can do a...
that is correct, before I upgrade the IOS version I can ping from vlan1.I did the upgrade, after that I can not ping from Ws-C2960 and from any outside PC or switch
There is the show ip interface brief:JUAFINASW1#show ip interface briefInterface IP-Address OK? Method Status ProtocolVlan1 10.131.0.10 YES NVRAM up upFastEthernet0/1 un...
There is the informationJUAFINASW1#sh cdp neiCapability Codes: R - Router, T - Trans Bridge, B - Source Route Bridge S - Switch, H - Host, I - IGMP, r - Repeater, P - PhoneDevice ID Local Intrfce Holdtme Capability Pla...
Hi LeoThis are the fiber ports configuration from the build 3 switch (WS-C3560)1.- To core switch upper right corner (WS-C4506) interface GigabitEthernet0/49 switchport trunk encapsulation dot1q switchport mode trunk spanning-tree ...
