Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
We have an 1100 Aironet AP running IOS 12.3(2). We are trying to connect a Zebra 105SL printer with the Wireless Print Server option where we are using a Cisco Aironet PCM352 PC Card. When the printer is turned on and starts to pull an ip address t...
Over the past couple weeks we have had a strange problem. Network access to an EMC NAS slows significantly for subnets that are not directly connected. Most other network activity seems normal. If the users reboot the problems goes away for a coup...
We have a 4506 switch with a supervisor IV engine. I configured an ip address to each VLAN interface in the network, and enabled them with the no shut command. I entered the ip routing command, and setup the default gateway to a cisco router that h...
I have a high level of broadcasts on a subnet. The highest is a mac address in the mac range on one of the modules on our Catalyst 4006. It using 15% of the bandwidth. Is there any way to determine if it is the switch module, or the switch acting ...
Aaron,We had firmware 60.13.0.3 but upgraded to 60.13.0.9 for the printer, but that made no difference. We also installed and test IOS 12.2(15)XR2 on the AP with both versions of the printer firmware and that solved the issue.IOS 12.3(2)JA does not ...
nizan,If you are running CatOS you can issue the "sh top util" command to see the highest utilized ports where is the number of top ports you want to see.Scott
The subnets that seem to have problem are the local subnets that need to be routed to the NAS. We have tested reading and writing to other servers from a problematic workstation with no problems.We have spaned traffic and monitored from the troubled...
The router is still in place and has a trunked interface for each vlan and subnet. I am trying to make the change transparently, so I am changing the default gateway on teh clients. If I change the gateway on any client to point to the switch every...
