Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi Guys,
I get a 20Mbps lease line between two offices and it connects two cisco C4507R switches. I configured QOS on both of the switches, and as I know the QOS will take effect when the network congestion happens. But the ports which the lease line...
Hi Guys,I have a question recently. There are four antenna connectors on the 3602E. Can I put 2 antennas outside the building and the others put inside the building? We are designing a mesh network. We want to put 2 antennas outside receiving the 5Gh...
Hi,guys Recently, I'm going to install AIR-ANT2440NV-R antenna for AIR-CAP3502E-C-K9. The Cisco document for AIR-ANT2440NV-R says it can be installed outdoor. But I'm worried about the line conneted between the antenna and the AP. Does it need to...
so what's the point to configure 'bandwidth' command under the interface? Will it make the QOS policy active when the network flow over the value configured by the 'bandwidth' command?
dear sebastian, I have the same problem, When I disable the ip cef on cisco2651xm, it works fine. When it is enabled, the internet is very low, but the vpn is ok, and the first packet ping to the internet is always lost. So, I have done with ...
