Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi all,
Our network comprises of the N7k & N5k, how do we find out the concurrent and limit connections using show commands ?
Thank you for all help.
Duc Vu
Hi all,I have a task on hand to locate the Cisco gears in our network (hundreds of them), got serial number but wonder if there is a smart way to find where that piece is ? rather than do "show version" on each device then look for serial number. Ple...
Hi all,I have an old switch C3524 running image "C3500XL-c3h2s-mz-120.5.2-xu". I had successfully created vlan 120 but when I config "interface vlan 120" as follows:swicth # conf tswitch(config-subif)#interface vlan 120switch(config-subif)#ip address...
Hi all,I'm new with WLC 5508 FlexConnect mode. I've just configured a new WLAN in WLC and want to set up simple password for smart phone users to connect to this WLAN for surfing the Internet. The idea is that phone users will choose this SSID then e...
Hi all,I have numerous of AP 3602i units connecting to a single WLC 5508 in FlexConnect mode. Two out of 46 AP units have been disassociating with WLC randomly. The only way to bring them back is to do a "shut/no shut" on switch port connecting to th...
Hi Cristian, Thank you for your effort. I look inot Cisco's FindIT as you suggested, it seems to be helpful tool for my responsibilities. Again thank you very much.
you're right. I just shut down interface vlan 10 (interface vlan 1 is down already) then interface vlan 120 comes up. Question is: if I need to configure several ports: some in vlan 10 and some in vlan 120 then should I have interface vlan 10 up too ...
after I remove the vlan 120 from one fastethernet interface, show run now sees the interface vlan 120 but in shutdown mode. Trying to do no shut but not help. Please advise.Thank you.
Thank you for all comments. I'm still struggling with the configs. In WLC 5508, there are choices of:WPA+WPA2 802.1x Static WEP Static WEP+802.1xCKIPNone + EAP Passthrough then if I chose "WPA+WPA2" then there is no space to put in Password ???
