Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello everyone,
I am trying to figure out the following task, if anyone could help me that would be great.
I neet to configure a vpn ipsec with gre between two routers. (R1 and R2).
R2 has:
statis public ip address.
its on another site so i cant c...
Hello everyone.
I have the following question.
R1 has one ip address which later traslates to a public ip address to form a vpn with other router R2.
Can i use the "ip XXXX XXXX secondary" command to create another ip (on the same subnet) so i can tr...
Hello everybody, I have the following problem. I was asked to filter routes from getting into the rip updates. The routes are static routes so its distance is 1 and its metric is 0. Knowing this the router learn the static route like connected and ...
Hello,My question is the following:i have the next scenario (attached 4 switches with stp.) My doubt is if its possible to do a monitoring of the blocked link between switch 3 and 2. Because we have had some problems with high latency in that link.I ...
Hello,I started to work in a network where there are a lot of cisco 861 and the routing protocol its Ripv2.We are having a big problem with the time convergion because we use 2 internet network providers that usually have problems and waiting 90 seco...
I was thinking the same thing, to translate the traffic. But i dont see how to do it. Do you have any example? (i know how to nat etc but i am not noticing how to apply the solution).
Thank Rahul for your answer.
That still has one problem. I need to have both vpn at the same time and having only one peer as destination forces me to only use one dialer at a time because it needs to be routed and it only uses one dialer in that sce...
Right now i dont have the config (not at the office) but i can tell you that R2 uses two identicall crypto maps (with different names).
Here is an example:
dialer 1 crypto map prueba-><-public ip1<- ip address 1.1.1.1/24
R2 ...
Dont worry Jon, if you want to do it, it would be a fun lab to do i guess! Running Eigrp is not possible sadly because the whole network (the 600+ nodes) are low end routers that only support rip. Im stuck with rip..Thanks again for your time!Regards...
Jon, thats correct.I missed that part when writing the explanation.The b.b.b.b network is of the v.v.v.v network.And its being redistributed because of the "interface" on the static route that learns the static route as connected
