I've enabled the following command "threat-detection service remote-access-authentication ... " on our Cisco ASA 5508X and it feels like it's only shun a maximum of 125 IPs. Is this possible? Does the ASA have a limit in number of IPs it can simultan...
Hi,This is what i'm trying to accomplish:CVPN --> Pix 515 --> Internet --> VPN PeerI have enabled both UDP 500 and ESP protocol for inbound and outbound traffic. Global command is configured to use Outside interface IP.NAT command is configured for L...
I would like to know how to configure the PIX 506 to allow inside hosts to establish VPN IPsec tunnel to an outside VPN device.I'm using a Global IP to NAT all outbound traffic.Thanks.
I replaced a Wathguard Firewall with a Pix 501. Since this migration, we are not able to establish a vpn tunnel with remote sites. Even if we use TCP 10000 port. The VPN software we are running is 4.0.5 and the Pix is running 6.3.3.Thank you,Sev
Hi patrick,This is what i get when i do the show commandsCan you tell me what to look for?Thank youshow crypto engine verifyFIPS: Known Answer Test beginFIPS: software DES success FIPS: software 3DES success FIPS: software AES success F...
Hi,In the example you provided; the Pix is configured with the static command. static (inside,outside) 99.99.99.12 10.1.1.2 netmask 255.255.255.255 0 0I my case, I do not have many valid Public IPs. I would like to be able to establish an IPsec tunne...
Hello Sachinraja,I do not have outbound filtering configured on the Pix. Do I have to open these ports and protocols for incoming traffic or both? I use NAT for outbound traffic configured with the global command.Thank you very much.Sev
