VPN IPsec thru a PIX 506.

[skelian]

I would like to know how to configure the PIX 506 to allow inside hosts to establish VPN IPsec tunnel to an outside VPN device.

I'm using a Global IP to NAT all outbound traffic.

Thanks.

[thisisshanky]

Hope this helps!

Use either static or conduit, but not both. The example listed does not indicate vpn clients though.

http://www.cisco.com/en/US/tech/tk583/tk372/technologies_configuration_example09186a008009486e.shtml

[skelian]

Hi,

In the example you provided; the Pix is configured with the static command.

static (inside,outside) 99.99.99.12 10.1.1.2 netmask 255.255.255.255 0 0

I my case, I do not have many valid Public IPs. I would like to be able to establish an IPsec tunnel using the GLOBAL IP:

global (outside) 1 99.99.99.50

nat (inside) 1 0.0.0.0 0.0.0.0 0 0

Will this work, is it doable?

Thank you