Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi everyone,I am trying to change the attribute of a summary route using attribute map. The attribute of the summary gets modified but the prefix is not being advertised to direct eBGP neighbor. route-map abc permit 10set community no-export router ...
Hi Friends,Need some of your thoughts regarding this scenario. I have a WAN1 CE router running BGP as exterior protocol and ospf as internal (With core switch). I have redistributed the static default route into core switch ospf process and the WAN1...
Hi, I have 2600 series AP registered with 2504 WLC over WAN working in Flexconnect mode. All of a sudden the AP lost connectivity to WLC and is operational in Flexconnect mode now.I am concerned whether it should rejoin again automatically ?(which di...
Hi All,Recently deployed Cisco Catalyst 3850-48P-E Stack Switch. I am receiving a lot of syslog messages ''''Controller port error, Interface Gi3/0/28: Power Controller reports Short detected''''Switch Software version : 03.03.02SE RELEASE SOFTWARE...
Hi All,I have 5 sites connected over MPLS-VPN. BGP is running as egp. All sites are ebgp with ISPI have a default route being learnt from ISP at all sites. I want to advertise default route from one of the MPLS sites so that others can reach here for...
Hi Robert,Thanks for your response!One thing, i have the normal BGP routes redistributed on WAN1 into ospf, which are learnt on Core Switch as LSA Type5. Would it cause any issues for these redistributed routes ?Otherwise this seems a perfect soluti...
Thanks for your response guys....! Below are the details :AP Model no. AIR-SAP2602I-Z-K9Software Version7.6.100.0i could ping CISCO-CAPWAP-CONTROLLER to correct IP address.Connection from remote site to controller site was also UP.(could ping both e...
