Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, We have a customer with two WLC.Some APs are connected to the WLC-1 (4400 series) with software version 7.0, and the others to the WLC-2, (5500 series) same version.Now we need to use 7.5 software version on the WLC-2 in order to use the newes...
We have a ISDN fax connected to a BRI port on the 2800 router. The BRI port is configured as layer 1 to 3 emulate network, so it can talk with fax.We have configured ad couple of DP :one (DP #10) to connect to the CUCM server via H323 session, and th...
Hi, a "simple" question.eBGP permit multihop configuration, so the two peers has not to be directy connected.In this scenario: (AS100) R1 -- R2 -- R3 (AS200)where R1 and R3 are the two bgp peers. This two routers has to specified a static routepoi...
I'm moving from a legacy PBX to IP Phone technologies.My dubt is very simple and it is about comparing legacy pbx to IpPhone features:if an external (PSTN) user calls me, I will put on hold the incoming call, place a call to an external (PSTN) numebe...
Hello Scott,Thanks, but I can't figure out to to this.I've made different mobility groups, no secondary WLC entries in the APs joined to WLC-1 etc...WLC-2 completely removed in every entries of WLC-1 APs, but still in every case, if I reboot WLC-1 th...
Hi,I added also the line max-pool 100at the "voice register global" sectionto resolve the issue.However the "mode cme" don't let me to add networks as id below the "voice register pool", so we have to choice to enable or not the "mode cme".Anyway ...
Are the "voice register pool" disabled on IOS images for the 7.x telephony service versions?We have upgraded the firmware of a Cisco2800 router, from an 12.4 XW release to an 12.4T one, in order to upgrade from CME4.2 to CME7.1.When IOS read configur...
Hi Lisa,Have you read carefully my message? I've successfully set a PPTP connection with a Windows workstation.What I am not able to do, is to establish a connection with a PocketPC based on Windows CE.Thanks anyway.Marco Pizzi
