Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,
I have 2 Cisco 4506 with Sup 7-E cards and I want to connect them with the 10 Gig fiber ports. I have the 2 10 Gig SFP's in them and configured the interfaces on both sides as just trunk ports
interface TenGigabitEthernet1/1 switchport m...
Hello all,
I need a little help creating a ACL that only allows internet access for our guest wifi users.
The guest WiFi range is from 10.1.160.3 to 10.1.175.254
We VLAN everything and use the VLAN number as the 3rd octet in the IP address. For exa...
Hello all, I hope someone can give me a config example or at least point me in the right direction for this.We are a large church with multiple locations and each location is connected back to the main campus by a gig wave circuit from Century Link. ...
Hello all,
We have a Cisco 4506-E and I need to add more fiver ports so I'm buying a WS-X4624-SFP-E line card and I was looking for some MM and SM SFP's to have on hand for them and found these which claim to do both. Am I understanding that correctl...
If I am creating a Class Map and Policy Map on the control room switch were the encoder is connected and I am stating that any traffic coming from 235.5.140.250 is to be classified as CS5 then on each switch down line that’s connected all the way to ...
Yeah so the problem is that the two locations are over the max distance. I got it to work between two buildings that are closer but the main one I really need is like 300m and I found that 62.5/125 µm Multimode Fiber can only do 10Gigabit up to like ...
@balaji.bandi wrote:
What is the distance of these device ? what mode of Fibre cable you using.
can you post
show run configuration
show run interface ten 1/1
show interface ten 1/1
show interface ten 1/1 capabilities
show inventory.
Sorry...
@thepaan01 wrote:Chris,Are the Gigabit links layer 2? If so, and the interesting multicast traffic is contained within VLAN 130, then you could allow only VLAN 130 on the new link and disallow it on the old link. However, why not just bundle the link...
What are you talking 1st and 2nd one? Are you referring to the list from that web page I sent?
I'm just asking about this one Cisco SFP-GE-L 1000BASE-LX/LH SFP
This is what it says on the website:
1000BASE-LX/LH SFP for Both Multimode and Single-Mode...
Thanks Joseph you are probably right. I'm not asking for some config assistance for just one switch but I really need a QOS expert to check each config I guess ad see what I am missing.I dont have any shaping or policing on anything but the 4506.I'll...
