Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello,Im facing some problems with ipsec vpn dynamic - static setup.I have working traffic over ipsec with one of my prefixes but cant add second one. For sanity i have removed configuraton not relevant and replaced IPs/object names byt bogus ones. D...
Hello, We are having some issues with L2L VPN IKEv2 IPSEC between two ASAs (5510 and 5506). ASA 5510 is static IP and 5506 dynamic IP. After X time, tunnel goes down and we see in static (5510) side that a "Username unknown" is logged for IKEv2.After...
Hello,
We seems to have some issues passing IPV6 traffic trough a cisco WS-C6509-E (R7000) processor.
Basically we have a WS-C6509-E x-connected TenGig port that terminates in a cisco ME-3600X-24FS-M (PowerPC8572) processor PO.
Software:
Cisco IOS...
Hello,
I am on the hunt for a good solution for gaming via VPN for older games that support only LAN connections.
I currently have anyconnect going and that works well and all if we manually enter the host IP.
My wish is to make games available in ...
Hello,
I am trying to figure out a way to force certain DNS names and traffic related to that "flow" trough VPN but im not sure if im doing it right - or if its even possible.
Config:
access-list VPN-SPLIT-TUNNEL standard permit 192.168.50.0 255.255...
Update to this if anyone experience the same problems. The fault is shown no to be a configuration or ASA related at all. The ISP for "Branch site" has dual devices with a 3G backup.When traffic changes to 3G for whatever reason and then changes back...
Ok so the tunnel went down again with same error. For reference: x.x.x.x is remote site y.y.y.y is local site (static ip). From ASDM Debugging log:Local:y.y.y.y:500 Remote:x.x.x.x:512 Username:Unknown IKEv2 Negotiation aborted due to ERROR: Failed to...
Hello,
If you want to use twice-nat you cannot use a service group as it wouldnt understand what port to map to which.
This should be what you are looking for:
object network TEST_PUBLIC_IP host 10.10.10.10
object network TEST_PRIVATE_IP host 1.1.1...
