Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Wierd thing.... done this on 4 pairs of ASA5516 (9.8(4)41) and it works...BUTon my 5515, (same software version) I get no hits on the acl i.e. a show access-list CPLANE_OUTSIDE shows (hitcnt=0)but in the logs I can see IP addresses in my object-gro...
This works for individual switches, but for stacks I get"'errors': ['This endpoint is not supported for switches in switch stack'Can't see the relevance the Layer 3 should be defined in 1 place?
We have this problem too. We have 2 enclosures with 16 blades, and 8 3120x in total, all joined.We couldn't get the SSH sessions to clear, telnet is blocked by access list. We have been waiting until after a change freeze to look at this further, but...
