Dear All,
I am having 3850 Switch act as a wireless controller since last 3 Years along with 3600 AP.
Now for expansion of our network along with MPLS location we purchase 5508 controller in HA along with 3802E Access Point.
In Controller we are con...
Dear Support, I am having the ASA 5515 and in this ASA CX module install for contain filtering.I have configure the some policy in CX module through PRSM GUI.I also enable ssh for CX module. My CX module is not have any problem all my policies are wo...
Dear Support, I have a Cisco SG300 and Cisco 3560 switches.3560 is my Core Switch and SG300 is access switch.On 3560 my all VLAN are configured and my PC which is connected to SG300 is not able to ping the gateway.From 3560 VLAN information is not pa...
Dear Support, I have a Cisco SG300 and Cisco 3560 switches.3560 is my Core Switch and SG300 is access switch.From 3560 VLAN information is not passed to SG300. 3560 Configuration:interface GigabitEthernet0/23switchport trunk encapsulation dot1qswitch...
Dear Nikolaj,Thanks for Your Reply.In Active Passive mode VPN will disconnect then if I deploy the ASA in Active Active Mode then also it will be disconnect or not.Regards,Jitesh Mahajan.
Dear Sandip,
Is their any other option with out uninstalling the 3850 Controller.
I want to use both the controller at a time.
I also have query of 3802 Access Point, can this 3802 Access Point is act as controller for small office like 3650 & 3850 ...
Dear Sandip,
Currently we are having 3850 switch act as a controller with 3602 AP since last 3 Years.
The expansion is going on in our current office along with some MPLS location.
so we brought 5508 Controller with HA along with 3802 AP.
First we c...
Dear Sandip,
Thank you for reply.
I was already updated the controller IOS from 8.0 to 8.2.121.
for the same updated the IOS of Access Point as well.
This IOS update activity is done on just 2 days back, But still the problem is remain.
AP is not re...