Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi,I've install the location appliance with the setup script and after I've rebooted the appliance. After the reboot I've check location server status (/etc/init.d/locserverd status) and I receive the following errorGetting the status locserverd: com...
HelloI've upgrade the controller 3750 from the version 4.1.171.0 to the version 4.1.181. After this upgrade few AP are not anymore associated to the controller and I receive the following messageFailed to authorize AP with Base Radio MAC 00:13:c3:4c:...
Hi,I need to add the command "dot1x guest-vlan" on Router 877 and I use the IOS 12.4T11. The command is not available on cli but I've found it on the documentation. http://www.cisco.com/en/US/products/ps6441/products_feature_guide09186a008077520e.htm...
I need to send Magic packet to clients and they are in different vlan. The server is in vlan5 and all clients are in vlan8, vlan9 and vlan10. Where I need to apply the command, on the server sending interface or on the client’s interfaces.
Thanks Gilles.I'd like to monitor when Siebel is down, the page server is responding but the default page is changing.When I try to use the get request the service goes down. Does the get request works with all the pages or is there any restriction?
