Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
When Prime backs up switch configuration automatically how is it doing this TFTP/FTP/SFTP or via SNMP?
We have a requirement to encrypt the traffic and to backup regularly but I can't see anywhere to control the schedule or the method of backup.
I'm trying to setup multi-area OSPF on our network to reduce the routing tables by summarising routes at the ABRs. The problem I've got is I have a switch that is connected to another switch which then connects to the ABR. When I put the two switches...
I've got a PIX firewall running 6.3(1) and I can't get any traffic to go from Outside to Inside and I can only get icmp traffic to go from Inside to Outside.I've tried to open it up completely so all traffic will flow (will the though to locking it d...
Does the configuration backup not get saved to the Cisco Prime box?
I thought you only needed an SFTP server if you were intending to save the configuration to an off-box repository?
I think I may have confused the matter by mentioning SFTP.
After looking into it I believe that Cisco Prime pulls the configuration of devices it knows about (switches, routers, etc...) using whatever settings you chose during Discovery i.e SNMPv3 ...
I found the answer but a bit of pure luck. The reason for the error was because it was receiving packet for 10.1.0.0 255.255.0.0 because the 10.1 network is extended out across all the sites But because 10.1.0.0 0.0.255.255 was in the core switch in ...
The end switch has a layer 2 edge switch attached to it that doesn't have OSPF setup on it, I have made all the interfaces other that those involved in OSPF passive. Here is the database: OSPF Router with ID (10.204.250.254) (Process ID 1...
