Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello all,I am working on a new pppoe setup and am hoping to configure HSRP/VRRP or something else to eliminate to possibility of hardware failure. Running on a 7206vxr box with the following (pertinent) configuration:pdn enableloopback 41ip address...
I hope I am clear with this, if I'm not - Sorry.I currently have a 2811 router in use as a backup vpn device, and working perfectly for the few locations that need its use. I now have a need that if a vpn request comes in from a specific IP address...
I am updating and combining a couple of routers. Router A is a 1711 router with a Single T-1 circuit. Router B is a 2611 with a single T-1 circuit and also a 2 port FXO card -both ports in use. The 2 ports are analog lines mapped to equivalent por...
I have two 6509s connected via fiber and running layer three OSPF routed traffic between them just fine. I now have a situation where I need a Layer 2 connection between the switches as well, going across the single piece of fiber. Possible? I can...
We are setting up a new network, and currently it has 4 6509s in two separate location, SiteA-BoxA, SiteA-BoxB, SiteB-BoxA, and SiteB-BoxB. There are fiber connections between the Box A's and between the Box B's. Is there a way to set up Etherchann...
If I remember correctly, when the circuit was plugged in, the controllers would show status up. The serial interfaces would be the ones that stayed down.Todd
Encapsulation is HDLC on both ends. Attached will be the show interfaces for the four serial interfaces.These interfaces are strickly data T-1s no Voice stuff at all. When I move the Active T-1 from a working external CSU to the S0/0/0:0 interface ...
Matt,The Platform/Software is - Cat6500 -12.2(18)SXD3. The problem is resulting from a Microsoft Term. Serv. Load Balancing setup. I don't know much more on the servers than that. They were built well before I came along. Your statement about stat...
