Simplex mode is the SYMPTOM of the problem. When the peer is down or Disabled, the active unit automatically goes to Simplex mode (because who would it fail over TO?)
Hi A Stevens. I have the exact sane problem here. What did you end up doing as a workaround exactly?
You said "Even if I make a own record-template with match and flow it works."
I know yours is a real old post but my question now is, How do you associate the DHCP pool with the VLAN 50? I have a different model switch but OS seems similar.
I found that DHCP service will NOT work unless there is an active layer 3 interface (S...
That was SOOOOOO It!!!
privilege [mode] reset [first line of commnand]
BAM! Clears the 'privilege level' junk Straight out of the run config
To be fair, I am not sure if this is what the original asker was going for but it was definitely MY issue.