Cisco 9800cl for cloud WLAN clients not getting IPI have created two additional VLANs ID 2 & 3 on the WLC 9800. The WLAN clients don't get IPs. I have my IP forwarding layer 3 router fully operational. The layer 2 switch as well. Wired devices get IP...
I have created two additional VLANs ID 2 & 3 on the WLC 9800. The WLAN clients don't get IPs. I have my IP forwarding layer 3 router fully operational. The layer 2 switch as well. Wired devices get IPs from the DHCP pools on router.I have tried every...
I have an SG300 28 ports and I face an issue. The DHCP is full, expired lease bindings are not reused and the new clients don't get issued IPs. BIOS version 1.4.8.6. I have to manually delete the expired bindings every week.Any ideas?
I'm using Microsoft Hyper-V. I have installed everything according to Cisco Catalyst 9800-Cl Cloud Wireless Controller Installation Guide updated: May10, 2021
I did and no packets were received. I believe is not a matter of DHCP but most likely the wlc controller cannot access the VLANs except of course the default VLAN 1. Once I create an SVI for VLAN 2 and choose to get IP from DHCP it fails to get an IP...
Thank you Marce1000. I am aware of the DHCP relay alternative solution…but as stated in the guide: DHCP bridging is the recommended and default mode of operation for the C9800. This means that the client DHCP traffic gets bridged at the controller in...
PAP works as per below link. Disable MPPE encryption on router, PPTP server as well.https://community.cisco.com/t5/small-business-support-documents/pptp-vpn-configuration-on-rv340-345-routers/ta-p/3220097