Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hello, Supposedly 2960x support eem past 15.2.(4) and currently on 15.2.7. Any pointers how to enable the Trap? Shows disable.Basically trying to have port shut/noshut on certain time. but when I check policy registered they show but off. Thank you i...
Hi,I'm trying to register the secondary ACS to the primary (log collector). When adding from secondary "Register to Primary" I'm getting the Connection timed out message (see below).I have confirmed they have reachability to each other and proper IP ...
I think I exhausted all possibilities where the fault may resides. Please note this is non vpc - vpc feature is not on. Tried bouncing the interface with no luck. What else could be the issue anybody? Thanks in advance.
N5K1(config)# sh int vlan 10...
Hi, Interested to find out if you can mix ESP40(one I'm starting bom with) with i.e ESP100(future ref)? For bandwidth purpose and HA. ASR1006x would be running on RP2. Any references would be appreciated.
service timestamps log datetime localtime show-timezonefixes it:Oct 2 16:16:17.359: %SYS-5-CONFIG_I: Configured from console by bmoadmin on vty0 (192.168.128.159)Oct 2 10:28:27 CST: %LINK-5-CHANGED: Interface GigabitEthernet0/14, changed state to adm...
Look I just did a quick shutdown to look at the log timing:Oct 2 16:13:29.563: %LINK-5-CHANGED: Interface GigabitEthernet0/14, changed state to administratively downOct 2 16:13:30.566: %LINEPROTO-5-UPDOWN: Line protocol on Interface GigabitEthernet0/...
M02@rt37so it seems like the eem works because wifi was lost at the giving time and recovered in the morning but logging is still confusing - not sure why I'm seeing reversed even though in real it works correctly look:Here it tells us it shuts down ...
Fixed the time, I'll see if the eem trigers todayshow event manager policy registered
No. Class Type Event Type Trap Time Registered Name
1 applet user timer cron Off Tue Oct 1 09:21:17 2024 Shutdown_Port
cron entry {45 23 * * *}
maxrun 20.000
action...
Time is good- EDIT, time changed it seems. Like I said, The logic is reversed on the script as per log. So instead of Shutdown_Port at 11:45 we have Enable_port and vice verse. Confirmed the cron time script and its correct so don't know why it would...
