Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Trying to get our LNS (7200) to exchange routes with L2TP DSL connection without success - I have the following:CE: (Not NAT Enabled, Assigned 10.0.0.2 to Dialer Int, and placed in vrf TEST10 via Radius)interface Ethernet0 description LAN ip address ...
Hi,Just attempting to have CE advertise the LAN subnet to PE, without success.On CE(No NAT enabled), I currently have:!interface Ethernet0 description LAN ip address 192.168.1.1 255.255.255.0 no keepalive!!router rip version 2 redistribute static net...
Just swapped out a 2924 with a 2950 (Copying config as closely as the 2950 would allow), and now icmp to Management IP is extremely latent (200m/sec+ from server connected directly to it)....icmp through the 2950 is unaffected.Spanning tree appears t...
Looking at the most scalable alternative for an LNS - We have looked at 7200's (Starting with NPE400, then potentially upgrading to NPE-G1 as required).Would 7600's be a better alternative?(Or 6400's?)...Or is there a new Cisco product that replaces ...
Thanks Martin - Works nicely!You stated that VRF NMS needs not to be configured on every PE - How would I add an interface to vrf NMS if it doesn't exist on the PE?Example:(On PE without NMS configured):#interface Loopback11(config-if)# description N...
Thanks for the reply - Loop10 is being assigned to DSL Int upon connection:Radius reply attribute:lcp:interface-config=ip vrf forwarding TEST10 \nip unnumbered Loopback10interface Loopback10 ip vrf forwarding TEST10 ip address 10.0.0.1 255.255.255.0S...
Thanks again for your assistance with this.I have added the Loopbacks IP to rip:PE:!interface Virtual-Template1 description L2TP-1 Termination ip unnumbered Loopback1 qos pre-classify ppp authentication chap callin!!interface Loopback1 description B...
