About Muhammad Thanveer

Muhammad Thanveer · ‎10-05-2018

Thanks for your Reply Friend, I will check it.

Muhammad Thanveer · ‎10-04-2018

How MPLS traffic can be forwarded through an IP fabric with no MPLS support ?

Muhammad Thanveer · ‎12-01-2016

Thanks Leo, I thought, we would have a chance to configure reload sequence kind of thing.

Muhammad Thanveer · ‎12-01-2016

Hello Folks, In case of power issues at site, Can we configure the stack members to wait for a manual restart, so the master comes up first and then the members. Any assistance is appreciated. Regards Mohammad

Muhammad Thanveer · ‎08-14-2016

Thank you so much for your response Marvin. Yeah I have seen qsfp used for nexus 7710. But one of my friends asked me about 2 pair fiber and type of sfp used for it in 3750 sw. Thanks once again for letting me know on this. BR Mohammad Thanveer

Muhammad Thanveer · ‎08-12-2016

Hello friend Thank you so much for the information provided. I would like to know what is two pair fibre cable and which type of sp does support them. BR Mohammad Thanveer

Muhammad Thanveer · ‎08-12-2016

Hello Friends, Some body today asked me, what is two pair fiber cable and does the switch 3750 (ws-c3750-24ts-s) support them. can somebody, please let us know on this. BR Mohammad Thanveer

Muhammad Thanveer · ‎05-17-2016

I go with Nagasheshu, Let the router do its Job.

Muhammad Thanveer · ‎03-30-2016

Thanks you so much for your reply friend. Yes that machine could be the one which doesn't got an IP from DHCP. This can be because of DHCP not releasing the IP or there is a basic connectivity issue. The point where in I am stuck is why this machine tried for an arp if the ip is not in the range of 10.1.0.125/24 If I am not wrong this can be same machines link local address, what do you say? I am literally confused friend. BR Mohammad Thanveer

Muhammad Thanveer · ‎03-30-2016

Dear Friends, can this be explained, please. (MAC is dummy) 34565 64.061324 dddd_67:8v:36 Broadcast ARP 56 Who has 169.254.255.255? Tell 10.1.0.125 this is an output from wireshark and what i understood is IP 10.1.0.125 is trying for mac with an arp request for 169.254.255.255 BR Mohammad Thanveer

Muhammad Thanveer · ‎03-05-2016

Hello Friend, Thanks for your reply. I understand that it will work, My question is If the switch port is a trunk port with native vlan 20 in my case, what will happen? Will we get native vlan mismatch on switch.

Muhammad Thanveer · ‎03-05-2016

Dear All, I have a set-up wherein my cisco switch port has trunked which is towards Cisco Phone and in turn a PC is connected. On switch my vlan for voice traffic is 20 and data is 10 on trunk port native vlan is 20 Cisco Switch------(Trunk)------Phone-----PC. Question No 1) will this set up work? Question No 2) Will we get native vlan mismatch on switch. Question no 3)what are the disadvantages or advantages of doing so. Note: I am unable to do this in Lab because of limitation of the devices available. I am aware that we basically do Access port on switch with voice and data vlan Allowed. Thanks in advance. All the useful comments will be rated. :) BR Mohammad Thanveer

Muhammad Thanveer · ‎01-26-2016

Thanks Mark, I have understood that this has something to do with per packet load balancing.

Muhammad Thanveer · ‎01-26-2016

Hi Mark, Hope you are doing good today. Thank you so much for your help, I have enabled the IP CEF on all the routers, but still I am unable to load balance it, I would like to know the reason why? I am going mad out of curiosity, hope you understand that. Thanks in advance :) BR Mohammad Thanveer

Muhammad Thanveer · ‎01-26-2016

Hello Mark, Thank you so much for your reply. I am able to understand that we need to enable IP CEF, Should we write default routes pointing towards both the interface IP addresses? I am unable to understand the statement, "on R3 set 2 default routes pointing to same next-hop" BR Mohammad Thanveer

Muhammad Thanveer · 10-05-2018 02:44 AM

Thanks for your Reply Friend, I will check it.

Muhammad Thanveer · 10-04-2018 12:27 PM

How MPLS traffic can be forwarded through an IP fabric with no MPLS support ?

Muhammad Thanveer · 12-01-2016 09:49 PM

Thanks Leo, I thought, we would have a chance to configure reload sequence kind of thing.

Muhammad Thanveer · 12-01-2016 05:39 AM

Hello Folks, In case of power issues at site, Can we configure the stack members to wait for a manua...

Muhammad Thanveer · 08-14-2016 07:44 AM

Thank you so much for your response Marvin. Yeah I have seen qsfp used for nexus 7710. But one of my...

Muhammad Thanveer · 08-12-2016 10:25 PM

Hello friend Thank you so much for the information provided. I would like to know what is two pair f...

Muhammad Thanveer · 08-12-2016 03:01 AM

Hello Friends, Some body today asked me, what is two pair fiber cable and does the switch 3750 (ws-c...

Muhammad Thanveer · 05-17-2016 03:23 AM

I go with Nagasheshu, Let the router do its Job.

Muhammad Thanveer · 03-30-2016 09:27 AM

Thanks you so much for your reply friend. Yes that machine could be the one which doesn't got an IP ...

Muhammad Thanveer · 03-30-2016 06:11 AM

Dear Friends, can this be explained, please. (MAC is dummy) 34565 64.061324 dddd_67:8v:36 Broadcast ...

Muhammad Thanveer · 03-05-2016 06:20 AM

Hello Friend, Thanks for your reply. I understand that it will work, My question is If the switch po...

Muhammad Thanveer · 03-05-2016 03:17 AM

Dear All, I have a set-up wherein my cisco switch port has trunked which is towards Cisco Phone and ...

Muhammad Thanveer · 01-26-2016 11:52 AM

Thanks Mark, I have understood that this has something to do with per packet load balancing.

Muhammad Thanveer · 01-26-2016 11:17 AM

Hi Mark, Hope you are doing good today. Thank you so much for your help, I have enabled the IP CEF o...

Muhammad Thanveer · 01-26-2016 01:26 AM

Hello Mark, Thank you so much for your reply. I am able to understand that we need to enable IP CEF,...

Date Registered	‎09-06-2012 03:37 AM
Date Last Visited	‎04-08-2019 11:23 AM
Total Messages Posted	528
Total Helpful Votes Received	291

Re: MPLS traffic can be forwarded throu...

MPLS traffic can be forwarded through a...

Thanks Leo, I thought, we

Configure Stack members to wait for a m...

Thank you so much for your

Hello friend

Two pair fiber cable

I go with Nagasheshu, Let the

Thanks you so much for your

uni-cast IP trying to broadcast to link...

Hello Friend,

switch port trunked towards Cisco phone...

Thanks Mark,

Hi Mark,

Hello Mark,

Re: MPLS traffic can be forwarded through an IP fabric with no MPLS support ?

MPLS traffic can be forwarded through an IP fabric with no MPLS support ?