Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi , is there any way to block ssh in vlan gateway .. for example .vlan 101ip address 172.18.1.1/24vlan 102ip address 172.18.2.1/24 i want to block ssh for vlan 102 gateway ip(172.18.2.1) address . Please let me know .
I have configured ipsec site to site between ASAS ..
Nat is configured on both end .. phase 1 is up and phase2 is not ..
There is something in the NAT , I have done correctly still phase 2 is not up , could you please find out ..
i have attached b...
Hi ,
I have configured site to site vpn configuration without Nat , its working fine .. after configured at its not working .
what i have done is i natted my lan segment to public interface for both the firewalls
i have connected direct between A...
i have two vlans vlan 100 and 101 , both are connected in different L2 switch ..vlan 100 and 101 having different subnet , they need to communicate each other .
we dont have l3 switch and router .
how to do that ?
canyone help me ..
thanks
I found the problem , problem is an ACL ,
i have configured below format on the both end.
access-list xxx extended permit ip object NATTED_IP object Real_ip ..
thanks
thanks for the quick reply .
i have verified the document , in that tunnel-group are configuring as same ip both the peers ?
can you clarify that ..
thanks
thanks for the reply
i have checked in the document .
theres two thing ,
vpc failure scenarios
vPC peer link failure
if peer-link is failure, secondary vpc shuts down all of its vpc member ports , still primary switch as a primary and contin...
