Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
Hi community, We have a Catalyst 9300 running IOS-XE 16.6.8. Long before that it was at some point running IOS-XE 16.6.3 with two SMU patches. Updates of the software were always done with the install add file ... command.When the switch boots it tri...
Hello Cisco Support Community,
while tryjng to bring our ISE 2.1 deployment to 2.3 we failed because we had a failure:
Failure: Failed to upgrade reusable condition, error= Failed to addCompoundLibraryCondition: <CONDITION-NAME>,reason: Library C...
Thank you so much for your tip. Updating to 16.9.5 worked just like you wrote.(Sorry for the late response but I did not get a notification for your post.)
Thanks for your reply.I tried the command but it did not do anything: request platform software package clean switch allThis operation may take several minutes...Running command on switch 1Cleaning up unnecessary package filesNo path specified, will ...
Thanks for the reply. Unfortunately according to show install summary the switch has no softwarte installed at all:show install summaryLoad for five secs: 2%/0%; one minute: 2%; five minutes: 2%Time source is NTP, 12:46:59.821 MEST Fri Jul 3 2020[ Sw...
Hello Karsten,thank you for testing the limit of the description field. Our old description was 270 characters long, so the limit is somewhere in that range. I still think, a overview over all field lengths could be helpful.However, this would not so...
