I have 2x2800 routers with NME-16ES-1G-P - 16-port 10/100 Cisco EtherSwitch Service Module installed in it.
I created L2tp tunnel using Physical interfaces on the routers. It works fine. laptops could ping each other.
Now I Want to create a L2TPt...
Hi There,
I have 2x2800 routers with NME-16ES-1G-P - 16-port 10/100 Cisco EtherSwitch Service Module installed in it.
I created L2tp tunnel using Physical interfaces on the routers. It works fine. laptops could ping each other.
Now I Want to cr...
Hi There,
Can anybody provide the step by step configuration of Virtual riverbed configuration for traffic. Virtual riverbed in installed on UCS e140S module fitted in Cisco 4431 router.
Cheers,
HI Julio,
I have Two routers directly connected with each other using port gi0/0.
Both routers have 16 port switch module connected within the router chassis.
Diagram of this topology is attached in my first post. Please have a look at it as well...
Hi Julio.
thanks for the suggestion however it didn’t work. I changed my config to adopt ur suggestion that all the connectivity should be based on sub interfaces.
So so I changed the interfaces on my both the router to subinterface i.e. changed t...
