Heads Up :
The post you are writing will appear in a public forum. Please ensure all content is appropriate for public consumption. Review the employee guidelines for the community here.
I am reading the new book, I would like to bring here doubts, errors or a simple exchange of ideas,I start with the first error foundCHAPTER 2 SPTpage 43: The logic to calculate which ports should be blocked between two non-root switches is asfollows...
CHAPETER 6 - Page 139 Example 6-11 shows the routing tables of R1. Notice that the static route across the seriallink is not installed into the RIB. Only the static route for the Ethernet link (10.13.1.0/24) withan AD of 10 is installed into the RIB....
PAGE 133 CHAPTER 6 Figure Figure 6-7 EIGRP Unequal-Cost Load Balancing The path from R1 to R3 via R1–R2–R3 has been assigned a path metric of 3328,and the path via R1–R4–R3 has been assigned a path metric of 5632. Correction The Figure 6-7 error in t...
Chapter 4: Multiple Spanning Tree Protocol - ERROR Example 4-3 Brief Review of MST Status *-> Error ! Spanning Tree information for Instance 0 (VLAN 30)MST2Spanning tree enabled protocol mstpRoot ID Priority 24578Address 0062.ec9d.c500This bridge is ...
Page 50 Figure 2-4 Convergence with Direct Link Failure Between SW1 and SW2 Phase 1. SW1 detects a link failure on its Gi1/0/1 interface. SW2 detects a link failure onits Gi1/0/3 interface.Phase 2. Normally SW1 would generate a TCN flag out its root ...
