About ekhabaro

ekhabaro · 02-24-2019

IntroductionPrerequisitesRequirementsComponents UsedConfigureNetwork DiagramConfigurationsVerification and troubleshooting Introduction This article describes how to prefer particular interface for DIA with help of vSmart data policy. Prerequisites...

ekhabaro · 02-22-2019

This article is also available on cisco.com now as well: https://www.cisco.com/c/en/us/support/docs/routers/sd-wan/214149-configure-multiple-transports-and-traffi.html IntroductionConfigurationProblemSolutionVerificationTroubleshootingReferences In...

ekhabaro · 02-22-2019

This article now available on CCO: https://www.cisco.com/c/en/us/support/docs/routers/sd-wan/214147-vedge-does-not-advertise-its-own-as-when.html IntroductionPrerequisitesRequirements Components Used Configure Network Diagram VerifyConclusionRelat...

ekhabaro · 02-22-2019

IntroductionTopology and configurationProblemSolution Introduction This article describes typical problem with a design of the redundancy when OMP path selection is enforced on a vEdge device and not on the vSmart controller that can cause to unwant...

ekhabaro · 02-22-2019

IntroductionComponents UsedConfigurevEdge router configurationCisco IOS-XE configurationVerify Introduction This article describes IPSec IKEv1 site-to-site VPN with pre-shared keys configuration in transport-vpn on vEdge between IOS device with VRF c...

ekhabaro · 10-15-2024

You can try to activate the old version via CLI then first: request pl soft sdwan soft activate <version as it is seen in show sdwan software output> If you want to reset the software, make sure the desired (old) version set to default first from vMa...

ekhabaro · 10-02-2024

usually it takes less than 10 minutes, can you connect via console and check?

ekhabaro · 09-30-2024

Unfortunately vEdge 100, 1000 and 2000 are mips64 based platforms and unlike ISR1100-4G and ISR1100-6G which can run both ViptelaOS and IOS-XE, vEdge mips64 based platforms can't run IOS-XE. You would need to replace them with modern devices, vEdges ...

ekhabaro · 09-30-2024

well, maybe it could be possible with help of some EEM script similar to this: event manager applet Monitor_Sessions event timer watchdog time 60 action 1.0 cli command "enable" action 2.0 cli command "show sdwan bfd summary | include total" acti...

ekhabaro · 09-30-2024

we marked 20.12.3.1/17.12.3a golden star marked last month, sorry for late reply. Actually you may expect 17.12.4/20.12.4 to be marked with golden start in a coming weeks already.

Member Since	‎10-06-2017 08:34 AM
Date Last Visited	‎10-21-2024 10:22 AM
Posts	206
Total Helpful Votes Received	351

User Statistics

User Activity

SD-WAN Configuration Example: How to prefer particular uplink for DIA

SD-WAN Configuration Example: Multiple transports and traffic engineering with centralized control policy and app route policy

SD-WAN TechTip: vEdge does not advertise its own AS when BGP routes are advertised into OMP

SD-WAN TechTip: OMP path selection corner case when egress path selection enforced on vEdge ("vSmart Doesn't Take into Account TLOC State on Remote vEdge")

SD-WAN Configuration Example: Site-to-site (LAN to LAN) IPSec between vEdge and Cisco IOS

Re: Downgrade is not supported from controller. For version 17.14

Re: How long should IOS-XE upgrade from Viptela code take?

Re: Upgrade Headend Vedge 2000 from viptela 20.3.7.1 to XE SD-WAN code

Re: SDWAN tunnel count alert

Re: vManage 20.12